How to Make a Vaporizer

Buying a vaporizer to use to smoke your marijuana with can be rather costly so if you can find a way to make the vaporizer yourself it can save you a lot of money. The steps you have to follow to create a vaporizer are not too complex and the supplies are easily accessible around your home or at a department store in your city.

Step 1
First off you will have to take a light bulb and cut it where the end of the metal screw is. After doing this you will have to take out all the wires in the bulb and be sure you don’t leave behind any glass in the bulb.

Step 2
Take a plastic bottle cap and drill two holes in it and put the bottle cap on the bulb and tape it to make sure it stays in place and makes the bulb sealed off and air tight. The only way anything can get in or out of the bulb now is through the bottle cap. Take a straw and place it in one hole and let the other hole stay open. The straw is used to inhale and the other hole is a smoker hole which will let excessive vapor out.

Step 3
Take your marijuana which is probably crushed down already and put it through the hole and into the bulb. If you are using larger bulbs then you might want to put the weed in before taping the cap into place. Take a lighter and use it to heat up the light bulb from underneath. This will cause the marijuana to heat up and it will begin to let out marijuana vapor once it starts to get hotter.

This is probably the easiest way to make a vaporizer at home as this method only needs materials which can probably be found in your house. The performance of this homemade vaporizer may not compare to an expensive vaporizer but it still works. The only problem with this type of vaporizer is that the bulb will crack after multiple uses so it won’t last too long.